网站首页
当前位置：首页 > 成功案例
| Use and maintenance of diesel generators | |
| <P>A-level maintenance (day care) <BR>l）检查发电机工作日报； l) Check the generator work daily; <BR>2）检查发电机机油平面、冷却液平面； 2) Check generator oil surface, the cooling liquid surface; <BR>3）日检发电机有无损坏、渗漏，皮带是否松弛或磨损； 3) The daily inspection generator for damage, leakage, whether loose or worn belt; <BR>4）检查空气滤清器，清洁空气滤清器芯子，必要时更换； 4) Check the air filter, clean air filter cores, if necessary, replaced; <BR>5）放出燃油箱及燃油滤清器中的水或沉积物； 5) release in the fuel tank and fuel filter the water or sediment; <BR>6）检查水过滤清器； 6) Check the water through filter; <BR>7）检查起动蓄电池及电池液，必要时添加补充液； 7) Check the starter battery and battery fluid, if necessary, add additional liquid; <BR>8）起动发电机并检查有无异响； 8) and check for any abnormal sound starter-generator; <BR>9）用空****清洁水箱、冷却器及散热网灰尘。 9) **** clean with empty water tanks, coolers and cooling network dust. <BR>Ｂ级保养 B-level maintenance <BR>1）重复A级每日的检查； 1) repeated daily A-level examination; <BR>2）每100至250小时，要更换柴油滤清器； 2) Every 100-250 hours, to replace diesel filter; <BR>所有柴油滤清器不可清洗． All diesel fuel filter is not clean. 只可更换。 Can only be replaced. 100至250小时只是一个弹性时间，必须要根据柴油实际的清洁程度而更换； 100-250 hours is a flexible time, must be based on the actual cleanliness of diesel and replaced; <BR>3）每200至250小时，要更换发电机机油及机油滤清器； 3) Every 200-250 hours, to replace the generator oil and oil filter; <BR>机油必须要符合美国API?CF级以上； Oil must be in U.S. API? CF level and above; <BR>4）更换空气滤清器（机组运行300-400小时）； 4) the replacement of air filter (unit operating 300-400 hours); <BR>要重视机房环境而决定更换空气滤清器的时间，此滤清器是可以用****清洁； Should pay attention to room environment and decided to replace the air filter of the time, this filter can be used **** clean; <BR>5）更换水过滤清器及添加DCA浓度； 5) Replace the filter and add water over the concentration of DCA; <BR>6）清洗曲轴箱呼吸阀滤网。 6) Clean crankcase breather valve filter. <BR>Ｃ级保养?机组运行2000-3000小时，请进行如下工作： C-level maintenance? Unit operation 2000-3000 hours, do the following work: <BR>重复A、B级保养 Repeat A, B-class maintenance <BR>1）拆下气门室盖，清洗油污、油泥； 1) Remove the valve chamber cover, clean oil, oil sludge; <BR>2）紧固各部螺丝（包括运行部分、固定部分）； 2) Tighten screws ministries (including the running part, fixed part); <BR>3）用引擎洁霸清洗曲轴箱、油泥、铁屑及沉积物； 3) Pa by cleaning the engine crankcase cleaning, oil sludge, iron and sediment; <BR>4）检查涡轮增压器的磨损程度并清洗积炭，必要时进行调校； 4) Check the wear on the turbocharger and clean coke, if necessary, adjust; <BR>5）检查、调整气门间隙； 5) Check and adjust valve clearance; <BR>6）检查PT泵、喷油器工作情况，调整喷油器行程，必要时进行调校； 6) Check the PT pump, fuel injector work, adjust the injector stroke, when necessary, adjust; <BR>7）检查、调整风扇皮带、水泵皮带的松紧，必要时进行调整或更换：清洗水箱散热网，并检查节温器的使用性能。 7) Check and adjust fan belt, water pump belt tension, if necessary, adjust or replace: cleaning water tank cooling network, and check the thermostat's performance. </P> <P>小修（即D级保养）（3000-4000小时） Minor repairs (ie, D-level maintenance) (3000-4000 hours) <BR>l）检查气门，气门座等磨损程度，必要时进行修理或更换； l) Check the valve, valve seat wear, etc., if necessary, repair or replacement; <BR>2）检查PT泵，喷油器的工作状况，必要时进行修理、调校； 2) Check the PT pump, fuel injector working conditions, if necessary, repair, adjustment; <BR>3）检查、调整连杆及各紧固螺丝的扭力矩； 3) Check and adjust the screw rod and the tightening torque; <BR>4）检查、调整气门间隙； 4) Check and adjust valve clearance; <BR>5）调整喷油器行程； 5) adjust the injector stroke; <BR>6）检查调整风扇充电机皮带的张紧度； 6) Check and adjust fan belt tension level charger; <BR>7）清洗进气支管的积炭； 7) Clean the intake manifold of carbon deposition; <BR>8）清洗中冷器芯； 8) washing in the cold core; <BR>9）清洗整个机油润滑系统； 9) Clean the engine oil lubrication system; <BR>10）清洗摇臂室、油底壳的油泥及金属铁屑。 10) Clean room arm, oil pan sludge and metal filings. </P> <P>中修（6000-8000小时） In repair (6000-8000 hours) <BR>（1）含小修项目； (1) with a small repair projects; <BR>（2）分解发动机（除曲轴外）； (2) decomposition of the engine (except crank outside); <BR>（3）检查缸套、活塞、活塞环、进排气门、等曲柄连杆机构、配气机构、润滑系统、冷却系统的易损零件，必要时更换； (3) Check the cylinder, piston, piston rings, inlet and outlet valve, such as connecting rod, valve train, lubrication system, cooling system of the vulnerable parts, if necessary, replaced; <BR>（4）检查燃料供给系统，调校油泵油咀； (4) Check the fuel supply system, adjust the oil pump nozzle; <BR>（5）发电机电球修理检测，清净油污沉积物，润滑电球轴承。 (5) detection of generator power ball repair, clean oil deposits, lubricate the ball bearings. </P> <P><BR>大修（9000-15000小时） Overhaul (9000-15000 hours) <BR>（1）含中修项目； (1) with the repair project; <BR>（2）解体全部发动机； (2) the disintegration of all the engine; <BR>（3）更换气缸体、活塞、活塞环、大小轴瓦、曲轴止推垫、进排气门、全套发动机大修包； (3) the replacement of cylinder, piston, piston rings, size of the bearing, crankshaft thrust pad, into the exhaust valve, full engine overhaul kits; <BR>（4）调校油泵、喷油器、更换泵芯、喷油头； (4) adjust the oil pump, fuel injector, replaced pump core, fuel injection head; <BR>（5）更换增压器大修包、水泵修理包； (5) the replacement overhaul turbocharger, water pump repair kits; <BR>（6）校正连杆、曲轴、机体等部件，必要时修复或更换。 (6) correction rod, crankshaft, and other parts of the body, if necessary, repair or replacement. </P> <P> </P> | |
| 来源：中顺发电机组 时间：2017/3/16 |  |
苏公网安备 32108802010434号